Lenze MCH Series - Manual (Page 61)

13435744_EDBMH01_v13 57
29 HAND SOURCE
This parameter selects the speed reference source that the drive will follow when it is in
HAND mode. The following options are possible:
KEYPAD The
p and q keys control the drive speed.
0-10 VDC The drive will follow a 0-10 VDC signal wired between TB-5A (+)
and TB-2 (-).
4-20 MA The drive will follow a 4-20 mA signal wired between TB-5B (+) and
TB-2 (-).
PRESET #1 - #4 The drive will run at a programmable preset speed. Refer to
Parameters 1-4.
MOP The drive speed is controlled by two contacts (one to increase the
speed and the other to decrease the speed). Program TB-13A
(Parameter 47) to DECREASE FREQ, and TB-13B (Parameter 48)
to INCREASE FREQ. Closing TB-13A to TB-2 will decrease the
speed, and closing TB-13B to TB-2 will increase the speed. Refer
to Section 14.2.4.
SELECTED The drive speed will be determined by whatever speed reference
is selected using the TB-13 terminals. Refer to Parameters 47, 48,
and 49.
30 CONTROL
This parameter affects how the H/O/A modes are selected, and also determines the
level of serial control. The following settings are possible:
NORMAL
H/O/A is selected from the keypad or terminal strip. The serial
link can be used for monitoring only; no serial start/stop or speed
control.
NORM NO HAND Same as NORMAL except HAND mode is disabled. AUTO mode
can be selected normally from the keypad or terminal strip.
SERIAL SPEED H/O/A is selected from the keypad or terminal strip. The serial
link can control the drive speed or PID setpoint, but only in
AUTO mode. In HAND and OFF modes, serial speed control is
disabled. No serial start/stop control.
S SPD / NO HAND Same as SERIAL SPEED except HAND mode is disabled.
AUTO mode can be selected normally from the keypad or
terminal strip.
SERIAL AUTO H/O/A is selected from the keypad or terminal strip. In AUTO
mode, only the serial link can start the drive. The serial link can
control the drive speed or PID setpoint in AUTO mode only.
S AUTO / NO HND Same as SERIAL AUTO except HAND mode is disabled. AUTO
mode can be selected normally from the keypad or terminal
strip.