Lenze 8200 series - Manual (Page 10)

Safety information
2-2 UOMu_^MVMO
Drive controllers contain electrostatically sensitive
components which can easily be damaged by
inappropriate handling. Electrical components must not
be damaged or destroyed mechanically (health risks are
possible!).
5. Electrical connection
When working on live drive controllers, the valid national
regulations for the prevention of accidents (e.g. VBG 4)
must be observed.
The electrical installation must be carried out according
to the appropriate regulations (e.g. cable cross-sections,
fuses, PE connection). More detailed information is
included in the documentation.
Notes concerning the installation in compliance with
EMC - such as screening, grounding, arrangement of
filters and laying of cables - are included in the
documentation of the drive controllers. These notes must
also be observed in all cases for drive controllers with
the CE mark. The compliance with the required limit
values demanded by the EMC legislation is the
responsibility of the manufacturer of the system or
machine.
6. Operation
Systems where drive controllers are installed must be
equipped, if necessary, with additional monitoring and
protective devices according to the valid safety
regulations, e.g. law on technical tools, regulations for
the prevention of accidents, etc. Modifications of the
drive controllers by the operating software are allowed.
After disconnecting the drive controllers from the supply
voltage, live parts of the controller and power
connections must not be touched immediately, because
of possibly charged capacitors. For this, observe the
corresponding labels on the drive controllers.
During operation, all covers and doors must be closed.
7. Maintenance and servicing
The manufacturer’s documentation must be observed.
This safety information must be kept!
The product-specific safety and application notes
in these Operating Instructions must also be
observed!
Show/Hide Bookmarks