Lenze 8200 series - Manual (Page 40)

Commissioning
5-8 UOMu_^MVMO
5.4 Optimisation of the operating
characteristic of the drive
_у гЙ~ел зС нЬЙ СзддзпбеЦ лЙннбеЦл узм Е~е беСдмЙеЕЙ нЬЙ ÅìêêÉåíI
нзкимЙ ~еЗ йзпЙк ЕЬ~к~ЕнЙкблнбЕ зк нЬЙ ЕзееЙЕнЙЗ ãçíçêK
vзм Е~е ЕЬззлЙ ДЙнпЙЙе нЬЙ Езенкзд гзЗЙл ÒsLÑJÅÜ~к~ЕнЙкблнбЕ
Езенкзд пбнЬ ~мнз ДззлнТ ~еЗ ÒsLÑJÅÜ~к~ЕнЙкблнбЕ Езенкзд пбнЬ
Езелн~ен s
ãáå
ÄççëíÒK fе ЕЬ~йнЙк RKQKN узм пбдд СбеЗ лзгЙ гзкЙ
беСзкг~нбзе нз ЬЙдй узм пбнЬ нЬЙ ëÉäÉÅíáçåK
5.4.1 Select the control mode
Code Name Possible settings IMPORTANT
Lenze Selection Info
C014 ¿ Operating mode -0- -0- Linear characteristic V~f
d
with
auto boost
-1- Square characteristic V~f
d
2
with auto boost
-2- Linear characteristic V~f
d
with
constant V
min
boost
-3- Square characteristic V~f
d
2
with constant V
min
boost
Control
modes of the
voltage
characteristic
Function D Under C014 you can set the control mode and the voltage characteristic.
D The V/f-characteristic control with auto boost enables a low-loss operation of single
drives with standard three-phase AC motors with load-dependent V
min
boost.
Show/Hide Bookmarks