Lenze 8200 series - Manual (Page 9)

Safety information
UOMu_^MVMO 2-1
2 Safety information
2.1 General safety information
Safety and application notes for controllers
EíçW içïJsçäí~ÖÉ aáêÉÅíáîÉ TPLOPLbb`F
1. General
During operation, drive controllers may have, according
to their type of protection, live, bare, in some cases also
movable or rotating parts as well as hot surfaces.
Non-authorized removal of the required cover,
inappropriate use, incorrect installation or operation,
creates the risk of severe injury to persons or damage to
material assets.
Further information can be obtained from the
documentation.
All operations concerning transport, installation, and
commissioning as well as maintenance must be carried
out by qualified, skilled personnel (IEC 364 and CENELEC
HD 384 or DIN VDE 0100 and IEC report 664 or DIN VDE
0110 and national regulations for the prevention of
accidents must be observed).
According to this basic safety information qualified
skilled personnel are persons who are familiar with the
erection, assembly, commissioning, and operation of the
product and who have the qualifications necessary for
their occupation.
2. Application as directed
Drive controllers are components which are designed for
installation in electrical systems or machinery.
When installing in machines, commissioning of the drive
controllers (i.e. the starting of operation as directed) is
prohibited until it is proven that the machine corresponds
to the regulations of the EC Directive 89/392/EEC
(Machinery Directive); EN 60204 must be observed.
Commissioning (i.e. starting of operation as directed) is
only allowed when there is compliance with the EMC
Directive (89/336/EEC).
The drive controllers meet the requirements of the Low
Voltage Directive 73/23/EEC. The harmonized standards
of the prEN 50178/ DIN VDE 0160 series together with
EN 60439-1/DIN VDE 0660 part 500 and EN 60146/DIN
VDE 0558 are applicable to drive controllers.
The technical data and information on the connection
conditions must be obtained from the nameplate and the
documentation and must be observed in all cases.
3. Transport, storage
Notes on transport, storage and appropriate handling
must be observed.
Climatic conditions must be observed according to
prEN 50178.
4. Erection
The devices must be erected and cooled according to the
regulations of the corresponding documentation.
The drive controllers must be protected from
inappropriate loads. Particularly during transport and
handling, components must not be bent and/or isolating
distances must not be changed. Touching of electronic
components and contacts must be avoided.
Show/Hide Bookmarks