Lenze 8200 series - Manual (Page 59)

Troubleshooting and fault elimination
UOMu_^MVMO 8-1
8 Troubleshooting and fault elimination
D
c~мднл ~кЙ бггЙЗб~нЙду беЗбЕ~нЙЗ об~ нЬЙ Зблйд~у зк лн~нмл
беСзкг~нбзе EЕЬ~йнЙк UKNFK
D qЬЙ С~мдн Е~е ДЙ ~е~дулЙЗ Ду млбеЦ нЬЙ Ьблнзку ДмССЙк EЕЬ~йнЙк
UKOF ~еЗ нЬЙ дблн бе ЕЬ~йнЙк UKPK qЬЙ дблн ЬЙдйл узм пбнЬ нЬЙ
Йдбгбе~нбзе зС С~ìäíëK
8.1 Troubleshooting
8.1.1 Display at the controller
aìêáåÖ зйЙк~нбзе пбнЬзмн ~е зйЙк~нбеЦ ãçÇìäÉI нЬЙ зйЙк~нбеЦ лн~нЙ
зС нЬЙ ЕзенкзддЙк бл Зблйд~уЙЗ зе нпз ibaë ~н нЬЙ Скзен зС нЬЙ ìåáíK
LED Operating status
green red
on off Controller enabled
on on Mains switched on and automatic start inhibited (AS_LC)
blinking off Controller inhibited
off blinking every second Fault message, check under C161
off blinking every 0.4 seconds Undervoltage switch-off
off off Programming mode
8.1.2 Display at the operating module
pн~нмл беЗбЕ~нбзел бе нЬЙ Зблйд~у беЗбЕ~нЙ нЬЙ ЕзенкзддЙк лн~íìëK
Display Meaning
OV Overvoltage
UV Undervoltage
IMAX Set current limit exceeded
TEMP Heat sink temperature near switch-off
Show/Hide Bookmarks