MK Diamond MK-101Pro24 JCS - Manual (Page 19)

19
MK-101 Pro24 JCS ASSEMBLY
ASSEMBLY
(A)
Align Cutting Head rear Pivot
Hole to the Post Pivot Shaft
and slide onto shaft.
(B)
Ensure Cutting Head stop is in
upward position.
(C)
Install the Cutting Head onto the
Post Pivot Shaft and install the
Adjusting Knob.
(D)
For maximum cutting length,
the Cutting Head should be
in the front pivot hole and the
Post should be in the rear post
retaining hole.
For small tiles (6" tile or smaller) the Cutting Head
should be in the rear pivot hole and the Post should be
in the forward post retaining hole. For large tiles and
maximum cutting length, the Cutting Head should be in
the front pivot hole and the Post should be in the rear
post retaining hole.
Move Cutting Head Stop in upward position when using
rear pivot hole and in the down position when using front
pivot hole.
NOTE:
Cutting Head Installation
If the cutting head is installed, go to the next step.
Follow the assembly instructions to prepare your MK-101 for operation.
NOTE:
NOTE: