MK Diamond MK-101Pro24 JCS - Manual (Page 22)

22
MK-101 Pro24 JCS SETUP
SETUP
Pre-start Inspection
Connecting the Water Pump
Prior to beginning work, a pre-start inspection of the saw should be performed.
Inspect for damage
(A)
Ensure the ON/OFF Switch
is in the OFF position.
(B)
Verify the Movable Cutting
Table moves freely.
(C)
Inspect the Diamond Blade for
damage – verify the blade is
correct for the material being cut.
(D)
Inspect the Pump Assembly
for damage – ensure the cord
is free of cracks or cuts.
(E)
Inspect the MK-101 Pro24 JCS
for damage – ensure the cord
is free of cracks or cuts.
To prevent pump
damage, the Water
Pump must be dis-
connected if cutting
dry cutting blade.
(A)
Connect the Cooling Transfer
Tube to the inlet connection
of the Blade Guard.
WARNING
1. To prevent the possibility electrical shock, the MK-101 MUST be de-ener-
gized when connecting the Water Pump.
2. To prevent the possibility of electrical shock, use only MK Diamond qualified
replacement parts
NOTE:
(B)
Connect the Water Pump power
cord to the connection found on
the back of the motor.