MK Diamond MK-101Pro24 JCS - Manual (Page 28)

28
MK-101 Pro24 JCS OPERATION
Off-angle Cutting
To cut angles other than 45º angles or Miters, a 90º Protractor (MK Diamond
Part No. 134569-MK) should be used.
CAUTION DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for which
it was designed.
NOTE:
(A)
Place the 90º Protractor on
the Ruler/Stop.
(B)
Set the desired angle and
tighten the thumbscrew.
(C)
Position the 90º Protractor
and tighten the
retaining thumbscrew.
(D)
Position the tile against the 90º
Protractor and the Ruler/Stop.
Turn the motor ON.
(E)
Verify proper cooling flow on
both sides of the blade (See
Maintenance Section to
increase/decrease flow).
(F)
Perform the cut. Turn the motor
OFF when work is complete.