MK Diamond MK-101Pro24 JCS - Manual (Page 36)

36
The MK-101 is designed with a power transmission belt. In order to ensure the MK-101 operates at peak
efficiency, the belt should be inspected monthly, and changed if the belt shows damage and/or excessive
wear.
(A)
Remove the Diamond Blade.
(B)
Remove the Cutting Head (See
Adjusting the Cutting Head).
(C)
Remove the Belt Guard. Loosen
the two top bolts.
(E)
Inspect the belt for cracks,
fraying, separation and wear.
Go to step H if replacement
required.
(D)
Remove belt guard
bottom bolt.
(F)
Check the belt for proper
tension if tension is correct, go
to step R (proper tension
1/8-inch).
(G)
Loosen the motor mounting
bolts, if re-tensioning only go
to step N.
(H)
Loosen the Motor Adjustment
Strap.
MK-101 Pro24 JCS MAINTENANCE
1. When a new belt is installed, it should be inspected and re-tensioned after the first
forty-eight (48) hours of operation.
NOTE:
Belt Inspection, Adjustment and Replacement
(I)
Push the motor toward the
front of the Cutting Head to
loosen the belt.