MK Diamond MK-101Pro24 JCS - Manual (Page 40)

40
MK-101 Pro24 JCS TROUBLESHOOTING
(A)
Allow the motor to cool and
depress motor Overload
Reset Switch. If motor does not
start, go to Step B.
BLADE STOPS TURNING
Verify circuit breaker at least 20 amps - if not, move to 20-amp circuit.
Verify circuit breaker is not tripped. If tripped, reset.
Check power source voltage is 120V - if not 120V, move to another circuit.
NOTE:
(B)
Verify all plugs fully installed.
Check Ground Fault Circuit
Interrupter