MK Diamond MK-101Pro24 JCS - Manual (Page 29)

29
MK-101 Pro24 JCS ADJUSTMENT
Adjusting the Cutting Head
For larger tiles and maximum cutting length, the cutting head should be in the
front pivot hole.
For small tiles (6" tile or smaller) The cutting Head
should be in the rear pivot hole and the Post should be in
the forward post retaining hole. For large tiles and maxi-
mum cutting length, the Cutting Head should be in the
front pivot hole and the Post should be in the rear post
retaining hole.
Move Cutting Head Stop in upward position when using
rear pivot hole and in the down position when using front
pivot hole.
CAUTION The Cutting Head is heavy! Care must be used when changing the position of the
Cutting Head.
NOTE:
NOTE:
NOTE:
(A)
Ensure the ON/OFF Switch
is in the OFF position. Unplug
the GFCI from the power source.
(B)
Remove the Blade.
Remove Adjusting Knob.
(C)
Remove the Cutting Head from
the rear pivot hole.
(D)
Install the Cutting Head onto
the front pivot hole.
(E)
Move Cutting Head Stop to
Down Position.
(F)
Install the Adjusting Knob.
(G)
Set cutting depth approximately
1/4 to 1/2 inch below the
surface of the Movable
Cutting Table.