MK Diamond MK-101Pro24 JCS - Manual (Page 31)

31
MK-101 Pro24 JCS CLEANUP
Cleanup
1. If an external water source was used, steps A through C may be skipped.
2. Dispose of waste water in accordance with applicable Federal, State and Local laws.
(A)
Clean the Water Pump
suction of all debris.
(B)
Place the Water Pump
In an external container.
(C)
Run the MK-101 until clear
water is seen at the blade
cooling ports (Approx. 1 minute).
Ensure the saw is disconnected before completing the remainder of the
cleanup process.
(D)
Remove the Water Basin
from the MK-101.
CAUTION
NOTE:
Ensure water is not forced into the motor casing when cleaning.
(E)
Clean the Movable Cutting
Table Guide Bar.
(F)
Clean the Movable Cutting
Table Roller Wheel Frame
Support.
(G)
Clean the remainder of the
MK-101.
CAUTION