MK Diamond MK-101Pro24 JCS - Manual (Page 41)

41
MK-101 Pro24 JCS TROUBLESHOOTING
Movable Cutting Table Misaligned
Preparation
If alignment problems are the result of a warped blade, a bent frame or bent
support arm, or, if alignment is off by more than 1/8-inch, contact the MK
Diamond Service Center – (800) 474-5594 Tools Needed:
The Movable Cutting Table of the MK-101 may become misaligned with the Cutting Head of the Tile
Saw over time. Should misalignment occur, perform the following steps to realign the Tile Saw.
NOTE:
(A)
Combination square (square)
12-inch or greater. 1/2-inch
Wrench or MK Triple Hole Box
Wrench and MK Open
End Wrench.
(A)
Remove Water Pan.
(B)
Inspect Diamond Blade
for damage.
(C)
Loosen front and rear
Guide Bar Retaining Bolts.