MK Diamond MK-101Pro24 JCS - Manual (Page 26)

26
MK-101 Pro24 JCS OPERATION
(A)
Remove the Adjustable
Cutting Guide.
(B)
Position the Dual 45º Flat Angle
Guide and tighten the
retaining thumbscrew.
(C)
Position the tile against the Dual
45º Flat Angle Guide and the
Ruler/Stop.
Turn on motor
(D)
Verify proper cooling flow on
both sides of the blade (See
Maintenance Section to
increase/decrease flow).
(E)
Perform the cut. Turn the motor
OFF when work is complete.
To cut diagonal, the Dual 45º Flat Angle Guide (MK Diamond Part No.
134557-MK) should be used.
CAUTION DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for which
it was designed.
Diagonal Cutting
NOTE: