MK Diamond MK-101Pro24 JCS - Manual (Page 35)

35
MK-101 Pro24 JCS MAINTENANCE
When installing the Retaining Screw, do not “cross-thread” and DO NOT over tighten
the screw.
Diamond Blade change-out
NOTE:
(A)
Locate the Shaft Lock pushbutton
on the underside of the Cutting
Head.
(B)
Remove Retaining Nut and
Outer Flange, depress and hold
the Shaft Lock push button and
loosen.
(C)
Remove the Diamond Blade.
(D)
Install the Diamond Blade
onto Blade Shaft.
(E)
Verify the Blade is seated on
the Blade Shaft and direction
of rotation is correct.
(F)
Install Retaining Nut and Outer
Flange, depress and hold the
Shaft Lock pushbutton and
tighten.