RKI Instruments SDM-E2 - Manual (Page 21)

Setting the Operational Parameters in Edit Mode • 16
6. If the EAGLE 2 is equipped with NiMH batteries and you wish to charge the
batteries, connect the charging cable at the front of the SDM-E2 to the
charging jack on the back of the instrument. The CHARGE LED will begin
flashing amber. If the batteries are fully charged, the CHARGE LED will
become solid green again after about 5 minutes. Typically a bump test or
calibration will be initiated before this happens. See “Charging an Instrument in
a Docking Station” on page 65 for a complete description of charging the
EAGLE 2.
WARNING: Do not plug the charger cable into a battery pack that contains alkaline
batteries. Do not attempt to charge alkaline batteries.
7. Press and hold the POWER ENTER RESET button on the EAGLE 2 until you
hear a beep, then release it. The EAGLE 2 will begin its power up sequence. If
a successful connection between the EAGLE 2 and the SDM-E2 occurs, the
home screen will appear on the EAGLE 2 display at the end of the startup
sequence.
NOTE: The screen shown above applies to a standard 4-channel EAGLE 2. If
your EAGLE 2 has less than 4 channels, the inactive channels will not
appear in the above screen or in any screens where channels are
displayed. If your EAGLE 2 has a different gas combination, your gas
names and auto calibration values will be different. All screens in this
chapter assume a standard 4-channel EAGLE 2.
CH4 50%LEL GAS1
OXY 12.0vol% GAS1
H2S 25.0ppm GAS1
CO 50ppm GAS1
---
---