SATEC PM174 Manual - Manual (Page 106)

Chapter 4 PAS Application Remote Device Control
106 Series PM174 Powermeters
1. From the “Status” box, select the
desired flag status.
2. Click on Send.
Device Diagnostics
Device diagnostic messages may appear as a result of the
PM174 built-in diagnostic tests performed during a start-up
and device operation.
To enter the Device Diagnostics dialog, check the On-line
button on the PAS toolbar, select Device Control from the
Monitor menu, and then click on the Device Diagnostics tab.
All diagnostic events are recorded to the Event log and can be
inspected via PAS (see
Viewing the Device Event Log ). The
diagnostics status is also recorded to a non-volatile register,