Rockwell Automation 842E EtherNet/IP Absolute Encoder User Manual - Manual (Page 37)

Rockwell Automation Publication 842E-UM001A-EN-P May 2012 29
Configuring the 842 E encoder using RSLogix 5000 Chapter 6
3. Then open the path AB_ETHIP1, ethernet. The encoder can be seen
with its IP address.
4. Install the add-on profile according to the instructions in Appendix A,
page 49.
Setting up the add-on profile
in RSlogix 5000 After you install the encoder add-on profile (see Appendix A, page 49), set up the
add-on profile; here is an example of the setup procedure.
1. Open RSLogix 5000.
2. Click File>New.
IMPORTANT Before proceeding, install the add-on profile (see Appendix A, page 49).