Rockwell Automation 842E EtherNet/IP Absolute Encoder User Manual - Manual (Page 44)

36 Rockwell Automation Publication 842E-UM001A-EN-P May 2012
Chapter 6 Configuring the 842 E encoder using RSLogix 5000
Module Info tab
The Module Info tab contains read-only data that is populated when the
controller goes on line (a program is downloaded or uploaded from the
controller).
The left panel, Identification, shows the vendor, product type, product code,
revision level, serial number, and product name.
The right panel, Status, shows the fault status, internal state (i.e. run mode) and
whether the file is owned and Module Identity.
The Refresh and Reset Module buttons are active when the controller is on line.
Refresh: Click this button to refresh the data in the window.
Reset Module: Click this button with care as it disconnects the module
momentarily and control will be interrupted. A warning window appears: “Click
Yes
or No as needed. Click Help for further information.”