Rockwell Automation 700-HX Multifunction Digital Timer - Manual (Page 12)

1 Publication 700-UM002B-EN-D - June 2010
Chapter
3
Functions
Settings For Advanced Functions
Output ON
count alarm
set value
Output ON
count monitor
value
(9999 x 1000 times) (0 x 1000 times)
Note: The monitor value is only displayed.
It cannot be set.
9999 0
~
(9999) (1)
9999 1
timr
timm
outm
otim
w
s s h s
（ 1 ms ） （ 20 ms ）
…… s
(A-1) (A-2) (A-3) (b-1) (b) ) Z ( ) S ( ) F ( ) E ( ) d ( (A)
z a-1 a a-2 a-3 b b-1 d e f s
m m
∼
Key protect
level
(KP-1) (KP-2) (KP-3) (KP-4) (KP-5) (KP-6) (KP-7)
kp-2 kp-1 kp-3 kp-4 kp-5 kp-6 kp-7
Set the key protect level using the keys.
Run mode
Power ON
Note: 1. If the mode is switched to the function setting mode during operation,
operation will continue.
2. Changes made to settings in function setting mode are enabled for the
first time when the mode is changed to run mode. Also, when settings
are changed, the timer is reset (time initialized and output turned OFF).
For details on operations in run mode, refer to 3-10.
See note 1. See note 2.
3 s min. 3 s min.
Function
setting mode
Timer mode
Output mode
Output time
Input signal
width
Time range
0.01 s to 99.99 s
(default setting)
0.1 s to 999.9 s
1 s to 9,999 s
0 min 01 s to 99 min 59 s
0.1 min to 999.9 min
1 min to 9,999 min
0 h 01 min to 99 h 59 min
Display
0.1 h to 999.9 h
Set Value
1 h to 9,999 h
Time Range List
0.001s to 9.999 s
Set the time range using the keys.
Set the timer mode using the keys.
Set the output mode using the keys.
Set each digit for the output time using the corresponding keys.
Press the mode button for several seconds to display the Time Range setting
screen.
(If the output time is set to 0.00, hold is displayed.)
Displayed for modes A, A-1, A-2, A-3, B, and B-1 only.
Set value
upper limit
Output on
count alarm
set value
Output on
count
monitor set
value
Set the key protect level using the keys.