Operation (repeat cycle function), Switching from timer to repeat cycle – Rockwell Automation 700-HX Multifunction Digital Timer User Manual
Page 16
Advertising
Publication 700-UM002B-EN-D - June 2010
Functions 3-5
Operation (Repeat Cycle
Function)
Switching from Timer to Repeat Cycle
The 700-HX is factory-set for timer operation. To switch to repeat cycle
operation, use the procedure given below. For details, refer to page
Appendix-2.
Elapsed cycle time
ON duty set as a percentage
Up/down keys used for analog
adjustment of the ON duty
Cycle time
ON duty (%)
Output control
Close
Open
Opening/closing valve
Fully closed
↔Fully open
0%
↔100%
ON duty
1
Power ON
Function
selection
Hold down for
1 s min.
Switch from timer operation to
repeat cycle
operation using the keys.
Timer/
repeat cycle selection mode
Run mode
m
Advertising