Rockwell Automation 700-HX Multifunction Digital Timer - Manual (Page 17)

Publication 700-UM002B-EN-D - June 2010
3-6 Functions
Settings for Advanced Functions
Run mode
Power ON
Function setting mode
From next page To next page
(1 ms) (20 ms)
(PNP input) (NPN input)
(Red) (Green) (Orange) (Red-green) (Green-red) (Red-orange) (Orange-red) (Green-orange) (Orange-green)
(Instantaneous) (Time-limit)
3 s min. *2
3 s min. *1
s h s s
s h s s
(DOWN) (UP)
OFF time
range
ON time
range
Timer mode
ON/OFF
start mode
Input signal
width
NPN/PNP
input
Display
color
Instantaneous/
time-limit
( ) ( ) ( ) ( )
Display Set Value
Time Range List
0.01 s to 99.99 s
(default setting)
0.1 s to 999.9 s
1 s to 9999 s
0 min 01 s to
99 min 59 s
0.1 min to
999.9 min
1 min to
9999 min
0 h 01 min to
99 h 59 min
0.1 h to 999.9 h
1 h to 9999 h
0.001 s to
9.999 s
Flicker
OFF start 1
Flicker
On Start 1
Flicker
OFF start 2
Flicker
On Start 2
20ms
up down
1ms
pnp
grn
2c 1c1c
red org r-g g-r r-o o-r g-o o-g
npn
…… s
…… s
toff ton tof1 ton1
For details, refer to Time Range List.
For details, refer to Time Range List.
F
unction setting mode
Set the OFF time range using the keys.
Set the ON time range using the keys.
Set the timer mode using the keys.
Set the repeat cycle mode using the
Set the input signal width using the keys.
Set the NPN/PNP input mode using the keys.
Set the display color using the keys.
Set the function (instantaneous or time-limit operation) for the instantaneous output (output 1)
using the Keys.
*1. If the mode is switched to the function setting mode during operation, operation will continue.
*2. Changes made to settings in function setting mode are enabled for the first time when the mode is changed to run mode.
Also, when settings are changed, the timer is reset (time initialized and output turned OFF).
.
keys.