Panel cutouts – Rockwell Automation 700-HX Multifunction Digital Timer User Manual
Page 31
Advertising
Publication 700-UM002B-EN-D - June 2010
4-2 Dimensions
Panel Cutouts
Panel cutouts are as shown below (according to DIN43700).
Note:
1. The mounting panel thickness should be 1…5 mm.
2. To allow easier operability, it is recommended that adapters are mounted so
that the gap between sides with hooks is at least 15 mm.
3. It is possible to mount timers side by side, but only in the direction without
the hooks.
A = (48n - 2.5)
0
With 700-HN132 attached:
A = (51n - 5.5)
0
60 min.
60 min.
45
+0.6
−
0
45
+0.6
−
0
15 min.
n side by side mounting
A
+1
+1
Advertising