Rockwell Automation 1336-GM6 Enhanced DeviceNet Communications Module - Manual (Page 135)

Appendix
D
Supported PCCC Messages
Appendix Objectives Appendix D describes the PCCC object, which allows existing
PLC-type controllers to connect to the DeviceNet network. In this
appendix, you will learn about the following:
• DF-1/PCCC support (1203-GU6 only).
• A list of supported PCCC messages.
DF-1/PCCC Support (1203-GU6
Only) The 1203-GU6 translates PCCC messages into SCANport messages
between the SCANport device and the module. To communicate to
the SCANport device, you need:
• A PC running software that can communicate and translate the
DF-1/PCCC messages supported by the module.
• A modem that supports full duplex communication (if you’re
connecting the modem to a serial port that utilizes point-to-point
DF-1 full duplex protocol at selected baud rates).