Rockwell Automation 1336-GM6 Enhanced DeviceNet Communications Module User Manual
Page 25
Installation
2-5
You must now edit the adapter’s node address, and you may want to
edit some of its other parameters. Refer to the following table for
information:
Removing the 1203-GU6 Communications Module
To remove the 1203-GU6 communications module, you need to:
1. If necessary, remove any serial connections from the DF-1 serial
port.
2. Remove the SCANport cable from the SCANport product and
then from the module. This will power down the module if the
SCANport product is powered.
3. Unscrew (using a 1/8" flathead screwdriver) and then unplug the
5-pin or 10-pin connector from the module.
4. Insert a flathead screwdriver into the module’s DIN rail tab
release and gently push the handle toward the module to release
the connection tab. Then pull the module up and off the DIN rail.
Figure 2.5
Removing the Module from the DIN Rail
If using:
Then refer to:
1203-GU6 module’s serial connection
Enhanced DeviceNet Module Using a
Serial Connection
1203-GU6 module’s DeviceNet connection