Rockwell Automation 1762-IR4 RTD/Resistance Input Module - Manual (Page 24)

Publication 1762-UM003A-EN-P - February 2003
2-6 Installation and Wiring
DIN Rail Mounting
The module can be mounted using the following DIN rails: 35 x 7.5
mm (EN 50 022 - 35 x 7.5) or 35 x 15 mm (EN 50 022 - 35 x 15).
Before mounting the module on a DIN rail, close the DIN rail latch.
Press the DIN rail mounting area of the module against the DIN rail.
The latch will momentarily open and lock into place.
Use DIN rail end anchors (Allen-Bradley part number 1492-EA35 or
1492-EAH35) for environments with vibration or shock concerns.
Panel Mounting
Use the dimensional template shown below to mount the module.
The preferred mounting method is to use two M4 or #8 panhead
screws per module. M3.5 or #6 panhead screws may also be used, but
a washer may be needed to ensure a good ground contact. Mounting
screws are required on every module.
TIP
For environments with extreme vibration and
shock concerns, use the panel mounting method
described below, instead of DIN rail mounting.
End Anchor
End Anchor