Rockwell Automation 1762-IR4 RTD/Resistance Input Module - Manual (Page 40)

Publication 1762-UM003A-EN-P - February 2003
3-6 Module Data, Status, and Channel Configuration
Configuration Data File
The configuration data file is shown below. Bit definitions are
provided in Channel Configuration on page 3-7. Detailed definitions
of each of the configuration parameters follows the table.
The default configuration of the table is all zeros, which yields the
following.
TIP
Normal channel configuration is done using
programming software. In that case, it is not
necessary to know the meaning of the bit
location. However, some systems allow
configuration to be changed by the control
program. Refer to your controller’s
documentation for details.
Table 3.2 Default Configuration
Parameter Default Setting
Channel Enable/Disable Disable
Data Format Raw/Proportional
Input/Sensor Type 100
Ω
Platinum 385
Temperature Units/Mode °C (not applicable with Raw/Proportional)
Open/Broken Circuit Response Upscale
Cyclic Lead Compensation Enable
Excitation Current 1.0 mA
Input FIlter Frequency 60 Hz