Rockwell Automation 1770-KF2 Data Highway or Highway Plus Interface Module User Manual - Manual (Page 171)

Error Reporting
Chapter 7
7Ć16
Code (If Applies)
EXT STS STS Meaning
Error
Code
PLCĆ3 WRITE COMMANDS
10 81 1. There are not at least 2 bytes of data after the end of the
block address.
2. There is an odd number of data bytes after the end of the
block address.
3. Sum of packet offset and size values specifies more than
65,535 words.
4. Sum of packet offset and size is greater than total
transaction size.
30 83 The local 1775ĆKA module has executed a shutdown request.
40 84 Backplane error (either memory parity or timeout/disconnect).
60 86 Keyswitch setting disallows access.
70 87 Local PLCĆ3 is in Program mode.
1 F0 231 There is an error in converting the block address
(major section > 63, context > 15, or section > 15).
2 F0 232 Three or fewer addressing levels specified in a PLCĆ3 word
address.
3 F0 233 Conversion of a file address to a block address resulted in more
than 9 addressing levels.
4 F0 234 Symbolic address not found.
5 F0 235 Symbolic address is of length zero or is longer than 8 bytes.
6 F0 236 1. Destination file not found.
2. Destination address does not point to a word (for
wordĆrange writes) or a file (for file writes).
3. Destination address specifies more levels than required.
4. First word of destination location does not exist.
7 F0 237 1. Any word in the total transaction does not exist in the
destination file.
2. For a file write, the source and destination files are not the
same size.
8 F0 238 Destination file size changed between packets of a multiĆpacket
transaction and became too small for the total transaction.
9 F0 239 There are more than 65,535 words in the source file.