Rockwell Automation 1770-KF2 Data Highway or Highway Plus Interface Module User Manual - Manual (Page 173)

Error Reporting
Chapter 7
7Ć18
Code (If Applies)
EXT STS STS Meaning
Error
Code
8 F0 238 The file size decreased between packets of a multiĆpacket
transaction and became too small for the total transaction.
9 F0 239 File is larger than 65,535 words.
A F0 240 Sum of total transaction size and PLCĆ3 address is greater than
65,535 bytes.
PLCĆ3 BIT WRITE COMMANDS
10 81 More than 4 bytes of data exist after the PLCĆ3 address in the
command message.
30 83 The local 1775ĆKA module has executed a shutdown request.
40 84 Backplane error (memory parity or timeout/disconnect).
60 86 Keyswitch setting disallows access to file.
70 87 Local PLCĆ3 in Program mode.
1 F0 231 Error in converting the block address
(major section > 63, context > 15, section > 15).
2 F0 232 Three or fewer addressing levels specified for a PLCĆ3 word
address.
3 F0 233 Conversion of a file address to a block address resulted in more
than 9 addressing levels.
4 F0 234 Symbolic address not found.
5 F0 235 Symbolic address is of length zero or more than 8 bytes.
6 F0 236 1. File not found.
2. Destination address does not specify a PLCĆ3 word.
3. The PLCĆ3 address specifies more levels than required.
4. Word specified by the PLCĆ3 address does not exist.
9 F0 239 File is larger than 65,535 words.
B F0 241 Remote station does not have access to the destination file.
Remote Error Codes
Remote error codes are those reported in a reply message from a remote
station that received a command message from the local PLC-3 station.
These error codes are stored under user symbol ERROR in the local
PLC-3 station.