Rockwell Automation 1746-HSRV SLC Servo Control Module User Manual - Manual (Page 37)

Publication 1746-6.1.2 - July 2000
4-2 Installing Your SLC Servo Module
To verify that you received what you ordered:
1. Check the label on each shipping carton with your order.
2. Check the items received against the bill of lading by matching
the equipment nameplate description with the material ordered.
Installing the SLC Servo
Module The first component you install is the SLC Servo Module. After
installation, you connect the other components.
Figure 4.1 SLC Servo Module with Door Open
Note: The two switches on back are not used.
The table below provides a legend for the SLC Servo Module LEDs.
IMPORTANT
Make claims for breakage and damage, whether
concealed or obvious, to the carrier as soon as
possible after receipt of the shipment. Allen-Bradley
gives the buyer reasonable assistance in securing
adjustment for damage claims.
When: This LED is on:
Power is applied RUN
The feedback signal or user-side
power is lost FDBK/U.PWR
RUN
FDBK/U. PWR
CONFIG INV
To Termination Panel
Not used