Rockwell Automation 1790D-NOV2/TNOV2 CompactBlock LDX Analog Modules - Manual (Page 29)

Publication 1790-UM001A-EN-P - March 2002
Installation and Wiring 2-13
Wiring the Modules
After the analog module is properly installed, follow the wiring
procedure below. To ensure proper operation and high immunity to
electrical noise, always use Belden™ 8761 (shielded, twisted-pair) or
equivalent wire.
ATTENTION
!
To prevent shock hazard, care should be taken when
wiring the module to analog signal sources. Before
wiring any analog module, disconnect power from
the system power supply and from any other source
to the analog module.
ATTENTION
!
Never connect a voltage or current source to an
analog output channel.
cable
signal wire
signal wire
drain wire
foil shield signal wire signal wire
Cut foil shield
and drain wire