Rockwell Automation 1790D-NOV2/TNOV2 CompactBlock LDX Analog Modules - Manual (Page 74)

Publication 1790-UM001A-EN-P - March 2002
B-6 PROFIBUS Modules Installation, Wiring, Module Data, Status and Channel Configuration
Panel Mounting
1. Place the block against the panel where you want to mount it.
2. Gently pull and position the expansion cover to the left.
3. Place a center punch, nail or similar device through the
mounting holes in the block and make two marks on the panel
(lower left and upper right corners of the module).
4. Remove the block and drill two holes in the panel to
accommodate each of the mounting screws.
5. Replace the block on the panel and place a screw through each of the
two mounting holes. Tighten the screws until the block is firmly in
place.
DIN Rail Mounting
1. Hook the top of slot of the block over the DIN Rail.
2. Pull down on the locking lever while pressing the block against the
rail.
3. Push up on the locking lever to secure the block to the rail
when block is flush against the rail.
CompactBlock LDX
1790-16BVO X
EXPANSION UNIT
16 INPUTS-DCPOWER
0
7 0
7
95mm
3.74in
41mm
1.6in
Expansion Cover
Locking Lever
f