Rockwell Automation 1771-QDC, D17716.5.85(Passport) MNL. PLASTIC MOLDING MODULE - Manual (Page 118)

Chapter
9
9-1
Span Your Valves
This chapter describes how to span your valves using direct-output
operation, and verify by running simple open-loop profiles.
ATTENTION: Before proceeding, be sure you completed all
previous chapters. Failure to do so could result in unpredictable
machine motion, with possible equipment damage and/or injury.
We show you how to span these valves:
injection pressure valve
injection velocity valve
pack/hold pressure valve
plastication pressure valve
plastication screw RPM valve
We also describe how to:
test valve linearity
set profile pressure alarms
The following table lists command blocks used in this chapter and
corresponding worksheets from chapters 7 and 8 that contain initial values.
Block: Worksheet
Injection Configuration Block (INC) 7ĆA
Injection Profile Block (IPC) 8ĆA
Pack Configuration Block (PKC) 7ĆB
Hold Configuration Block (HDC) 7ĆC
Pack/Hold Profile Block (HPC) 8ĆB
Plastication Configuration Block (PLC) 7ĆD
Plastication Profile Block (PPC) 8ĆC
Chapter Objectives
Referenced Worksheets