Rockwell Automation 1771-QDC, D17716.5.85(Passport) MNL. PLASTIC MOLDING MODULE - Manual (Page 35)

Configure the QDC Module's I/O
Chapter 3
3-4
To determine initial sensor configuration values, refer to Table 3.A and
specifications that accompanied your sensors, valves, and cylinders. Write
down applicable values on Worksheet 3-D.
Important: You must enter floating-point numbers and percentages as
integers, so we recommend that you write them in Worksheet 3-D in the
following format: Use an assumed decimal point position that depends on
the range value. For example:
If the Range is: And You Want to
Enter this Value:
Use this
Format:
0 Ć 099.99% 75% 07500
0 Ć 99.99 inch 7.32 inch 00732
0 Ć 0999.9 mm 432.6 mm 4326
4.00 Ć 020.00 mA 16mA 01600
0 Ć 010.00 vdc 5.6 vdc 00560
0 Ć 009.99 sec 0.47 sec 00047
0 Ć 09999 psi 321 psi 00321
0 Ć 0999.9 Bar 222 Bar 2220
Table 3.A
Determine Initial SensorĆconfiguration Values for Worksheet 3ĆD
Category: If your: Then Use a Value Equal to:
Minimum Position
(Line 1)
N/A zero
Maximum Position
(Line 2) ram (screw) is fully extended
to the mold end (ram bottom)
full travel of the sensor
Analog Signal @ Min Position sensor is forwardĆacting low end of your selected range
(Line 3) sensor is reverseĆacting high end of your selected range
Analog Signal @ Max Position sensor is forwardĆacting high end of your selected range
(Line 4) sensor is reverseĆacting low end of your selected range
Minimum Pressure
(Lines 5 and 13)
N/A minimum range value specified by the
manufacturer
Maximum Pressure
(Lines 6 and 14)
N/A maximum range value specified by the
manufacturer
Determine Initial
SensorĆconfiguration Values