Rockwell Automation 1784-PKTCS ControlNet PCI Scanner Card Installation Instrucitons - Manual (Page 56)

6-16 Use IOView to Verify the Configuration
Publication 1784-IN042A-EN-P - April 2005
Change the View State
When the view is initially created, the view state is set to Idle. The view state must be set to
Run in order for the I/O adapters and I/O modules to energize their outputs based on the
output data associated with the view.
Set the view state to Run by selecting the Run radio button on the IOView screen. Once the
view state is set to Run, active outputs are sent to the associated output devices.
Delete a View
To delete a view, either:
• In the left-hand pane of the IOView screen, select the view to be deleted, then select
Edit ⇒ Delete View.
• Select File ⇒ Exit to shut down IOView.
ATTENTION
Changing the view state to Run will cause the I/O adapters and I/O
modules to energize their outputs based on the output data associated
with the view.
Produced data for a Send Data connection will be sent to the consuming
device and consumed data for a Receive Data From connection will be
received from the producing device regardless of the view state.
To avoid personal injury and property damage, before setting the view
state to Run, verify that the output values are appropriate for the
consuming devices.
Select the Run radio
button to change the
view state to Run.