Rockwell Automation 2100 CENTERLINE Low Voltage Motor Control Centers - Manual (Page 50)

50 Rockwell Automation Publication 2100-IN012E-EN-P - February 2012
Chapter 4 Installing and Removing Plug-in Units
Remove a Plug-in Unit with
a Vertical Operating Handle
from a Section
1. Make sure the disconnect handle is in the OFF/O position.
2. For non-arc resistant units, turn the door latches 1/4 turn; for units that
are equipped with arc-resistant door latches, push in the latch and rotate
1/4 turn.
Arc Containment Latch