Rockwell Automation 2100 CENTERLINE Low Voltage Motor Control Centers - Manual (Page 56)

56 Rockwell Automation Publication 2100-IN012E-EN-P - February 2012
Chapter 4 Installing and Removing Plug-in Units
b. Remove the hinge pins by sliding upward with a flathead screwdriver.
The control station can be hung on the front of the unit by using square
holes adjacent to the top unit latch.
c. Swing the door to near closed position.
d. Lift the door outward to remove.
.
For Units With Follow This Step
A control station First slide the hinge pin out of the hinge and through the tab on
the control station wiring.
ArcShield units with
100 ms arc duration
rating Two hinges are required for each hinge leaf.
1. The upper hinge on each door must be removed from the
structure to remove the uppermost hinge pin.
2. Remove the hinge pin through the lower hinge, then through
the hinge leaf and upper hinge.
Only top hinge
must be removed
to install hinge
pin.
Hinge
Hinge Pin
Hinge Leaf
Hinge for ArcShield Units with 100 ms Arc Duration Rating