Rockwell Automation 2100 CENTERLINE Low Voltage Motor Control Centers User Manual
Page 53
Rockwell Automation Publication 2100-IN012E-EN-P - February 2012
53
Installing and Removing Plug-in Units Chapter 4
7.
Remove other cables or devices that would prevent the unit from being
withdrawn.
.
8.
Pull the unit forward (outward) approximately 3 in. (7.5 cm) out of the
MCC, using the handle provided at the lower left of the unit and the tab in
the upper right of the unit as finger holds.
You may need to reposition your hands as necessary to properly support
the unit while you are removing the unit from the MCC.
TIP
It is not necessary to place wires and terminal blocks into the
vertical wireway to remove a plug-in unit that includes the wiring
clearance tunnel.
ATTENTION: Plug-in MCC units may be heavy or awkward to
handle. Use an assistant or a platform lift device if necessary to
help you handle the unit.