Rockwell Automation 9220-WINTA ControlNet Traffic Analyzer Reference Manual - Manual (Page 69)

Publication 9220-052C-EN-P - August 2002
Other Commands and Options 7-5
The Hardware Settings dialog box is shown below.
Click on a device and then click OK, even if there is only one device
listed. You can choose a card only if it is the correct hardware version
(i.e., CNA20.01.04.18 or higher) and if the card is not locked by
another application.
The tool will go into online mode and now whenever you launch the
Traffic Analyzer tool, it will launch into online mode using the device
you selected. You can go into offline mode by choosing
Actions>Offline.
Once you have chosen the hardware setting, it becomes the default
setting until you change the setting or remove the card. If you remove
the card, the next time the Traffic Analyzer tool is launched, it will try
to go on line but will not find the hardware.
You will see the following error message:
Identifies the PC
card slot number
(Windows 95 only).
Identifies the CN-1000 ISA
card or the 1784-PCC PC card.
Identifies the dual-port
memory address.
Identifies the
interrupt number.
“Yes” indicates an application
is using the card and therefore
the card is unavailable to other
applications. “No” indicates
the card is available to use.
Accept the selected device
as the online mode default. Update the hardware settings dialog box after a device has
been added or removed. Important: Use the Refresh button
to see a change in status of an application or hardware
without having to close and open the dialog box.
Identifies the
application under
which the device is
locked.
Identifies the
firmware version
of the device.