Rockwell Automation 2080-LC50 Micro800 Programmable Controllers: Getting Started with PanelView Plus - Manual (Page 15)

Rockwell Automation Publication 2080-QS003A-EN-E - September 2014 15
Chapter
2
Create a PanelView Plus Project
Introduction
In this chapter, you will learn to use the FactoryTalk View Machine Edition software to create a PanelView Plus project and
an application. This application will then be used in the next chapter to illustrate how to interact with the global variables
of a Micro800 controller.
Create a PanelView Plus Project
In this section you will learn how to create a PanelView Plus project and configure it to communicate with your Micro800
controller.
To begin, launch the FactoryTalk View Machine Edition software.