Rockwell Automation 2706-NP3 DL20 OFFLINE PROGRAMMING MANUAL - Manual (Page 11)

Installing the Software
Chapter 3
3–2
Computer with 1 Hard and 1 Floppy or Micro Disk Drive
This section shows how to install the DL20 Offline Programming Software
on a personal computer with 1 hard drive and 1 floppy or micro disk drive.
The installation procedure creates a DL20 subdirectory for storing the
programming software (DL20.EXE) and all other DL20 files created with
the software.
The prompts and responses you see below will be identical or similar to what
you see on your computer display.
1. Turn on your computer. Your computer will display the currently active
drive: A, B or C. For example:
C:>
2. Create a DL20 subdirectory on your hard drive using the MD command.
C:> MD \DL20 [Enter]
C:>
3. Move to the new DL20 subdirectory using the CD command.
C:> CD \DL20 [Enter]
C:\DL20>
4. Insert the appropriate installation disk for the DL20 Offline Programming
Software into the floppy drive.
5. Type the following command line to copy the DL20 Programming
Software into the DL20 subdirectory.
C:\DL20> COPY A:DL20.EXE [Enter]
1 file(s) copied
The DL20 Programming Software is now installed on your hard drive.
6. Remove the installation disk from the floppy drive and store it in a
safe place.
See page 3–5 for details on initial startup.
Installing the DL20
Programming Software