Rockwell Automation 2706-NP3 DL20 OFFLINE PROGRAMMING MANUAL - Manual (Page 22)

Configuration Functions
Chapter 4
4–7
Menu option 5 - Set Up DL20 Special Functions lets you:
•
Specify an Autorun Message number.
•
Specify a Background Message number.
•
Specify a Master Address (for serial message triggering only).
•
Enable/Disable Dynamic Message Chaining.
•
Enable/Disable DL20 relay when batteries are detected as low.
•
Enable/Disable the display of certain error messages.
Special Function settings are saved to the file MSTRFILE.DAT on disk or
the DL20 subdirectory. This file is transmitted to the DL20 at download.
For a complete description of DL20 Special Functions, refer to the DL20
User Manual.
To configure special functions for the DL20 Display:
1. Type 5 and press [Enter] to select 5 - Set Up DL20 Special Functions
from the Main Menu.
The following screen appears.
To accept the default values
press [End] to save settings
and return to Main Menu.
2. Enter a number to assign as the Autorun Message. Valid
message numbers range from 0 to 1022. The default is 0, which
means there is no autorun message. Press [Enter] to accept the default
or type another number and press [Enter].
3. Enter a number to assign as the Background Message. Valid
message numbers range from 0 to 1022. The default is 0, which
means there is no background message. Press [Enter] to accept the
default or type another number and press [Enter].
Configuring Special
Functions of DL20