Rockwell Automation 2706-NP3 DL20 OFFLINE PROGRAMMING MANUAL - Manual (Page 23)

Configuration Functions
Chapter 4
4–8
4. Specify whether you want to enter a Master Address for triggering
messages. Valid responses are Y or N. The default is N which means a
master address is not set. To accept the default, press [Enter].
To specify a master address, type Y and [Enter]. This prompt appears:
Press [Enter] to accept the default address of 0 or type another address
in the range of 0 - 127 and press [Enter]. Invalid master address
values are listed on the screen.
5. Specify whether you want to enable Dynamic Message Chaining. Valid
responses are Y or N. The default of N disables dynamic message
chaining. To accept the default, press [Enter]. To enable dynamic
message chaining, type Y and [Enter].
6. Specify whether you want to enable a relay when the DL20 detects that
the lithium batteries are low. Valid responses are Y or N. The default of
N disables this function. To accept the default, press [Enter]. To enable a
relay, type Y and [Enter].
7. Specify whether you want to flag errors that are illegal message triggers
(invalid triggers for non-existent messages) or invalid variable triggers
for illegal numbers. Valid responses are Y or N. The default of N does not
flag errors. To accept the default, press [Enter]. To flag errors, type Y
and [Enter].
8. Press [End] to save the special function settings to MSTRFILE.DAT
and return to the Main Menu.
Press [Esc] to quit and return to the Main Menu without saving changes.
Configuring Special
Functions of DL20