Rockwell Automation 2706-NP3 DL20 OFFLINE PROGRAMMING MANUAL - Manual (Page 14)

Installing the Software
Chapter 3
3–5
The steps below show how to start the The DL20 Offline Programmer on a
computer with a hard drive. Other systems may require different steps as
described in the installation section.
1. Move to the DL20 subdirectory if necessary.
C:\> CD DL20 [Enter]
C:\DL20>
2. Type DL20 and press [Enter] to start the DL20 Offline Programmer.
C:\DL20> DL20 [Enter]
Each time you enter the programmer, this screen appears.
3. Select the type of monitor you are using by entering 1 or 2 and [Enter].
The Main Menu appears.
All menu functions are described in the remaining chapters of this manual.
Initial Startup