Rockwell Automation 1786-series ControlNet Coax Media Planning and Installation Guide User Manual
Rockwell Automation Equipment
Advertising
Table of contents
Document Outline
- CNET-IN002B-EN-P, ControlNet Coax Media Planning and Installation Guide
- Summary of Changes
- Table of Contents
- Preface
- 1- ControlNet Cable System Overview
- 2- Plan a ControlNet Coax Media System
- Introduction
- Determine the Number of Taps You Need
- Choose the Connection for Programming Devices
- Choose the Cable Type
- Determine Trunk Cable Section Lengths
- Decide the Number of Terminating Resistors
- Determine Repeater Requirements
- Determine Propagation Delay
- Choose Connectors
- Decide Whether to Use Redundant Media
- Decide Whether You Need IP67 Media
- Follow Application and Installation Guidelines
- Plan the Tap Connections
- Review the Plan, Order Components
- 3- Install a ControlNet Coax Media System
- Introduction
- Install the Trunk Cable
- Plan the Taps Installation
- Install a Repeater
- Install Cable Connectors
- Obtain the Toolkit
- Calibrate the Cutting Blades
- Strip the Cable
- Attach the Connectors to the Cable
- Test for Electrical Shorts and Continuity
- Connect Cable Sections
- Terminate Segments
- Connect Devices
- Appendix A- Mounting Dimensions
- Appendix B- Maintain the Cable Strip Tool
- Glossary
- Index
- Back Cover