Change the memory blade holder – Rockwell Automation 1786-series ControlNet Coax Media Planning and Installation Guide User Manual
Page 71
Advertising
Publication CNET-IN002B-EN-P - June 2010
71
Maintain the Cable Strip Tool Appendix B
6.
Swing the memory blade holder closed.
Change the Memory Blade
Holder
You received two memory blade holders with your cable strip tool; one is for
PVC-CL2 cable, and the other is for plenum FEP-CL2P cable. You need to
install the appropriate memory blade holder for the type of cable you are
stripping (
).
1.
Lift the latches on the memory blade holder and swing it back.
2.
Snap the memory blade holder off the rod and remove it from the
strip tool.
3.
Position the appropriate memory blade holder on the rod and snap the
holder into place.
20069-m
20182-m
20070-m
Advertising