Appendix b- maintain the cable strip tool, Introduction, Reverse or replace the cutting blades – Rockwell Automation 1786-series ControlNet Coax Media Planning and Installation Guide User Manual

Page 69: Appendix b, Maintain the cable strip tool, Introduction reverse or replace the cutting blades, Appendix

Advertising
background image

Publication CNET-IN002B-EN-P - June 2010

69

Appendix

B

Maintain the Cable Strip Tool

Introduction

This appendix provides instructions to perform maintenance tasks on the
cable strip tool, supplied with the ControlNet Coax Toolkit (1786-CTK).

Reverse or Replace the
Cutting Blades

Follow these steps to reverse or change the cutting blades.

1.

Use a screwdriver to lift the memory blade holder and swing it back.

2.

Slide the memory blade cartridge out of the strip tool.

ATTENTION

Use care when using the cable strip tool to avoid
personal injury.

20182-m

Advertising
See also other documents in the category Rockwell Automation Equipment: