Connect devices – Rockwell Automation 1786-series ControlNet Coax Media Planning and Installation Guide User Manual
Page 61
Publication CNET-IN002B-EN-P - June 2010
61
Install a ControlNet Coax Media System Chapter 3
Connect Devices
After terminating your segments, connect your devices by:
•
programming terminals through the NAP.
•
the repeater to a ControlNet link.
To connect the ControlNet processor, adapter, or programming terminal via a
communication interface, follow these procedures.
1.
Remove and save the tap’s dust cap on the straight or
right-angle connector.
2.
Connect the tap’s straight or right-angle connector to your device.
If your node
supports
Connect the tap’s straight or right-angle connector
Non-redundant
media
To the channel A connector on the device (channel B is not used)
(1)
(1)
While both channels are active, Allen-Bradley recommends using channel A for non-redundant media.
Redundant
media
From trunk cable A to channel A on the your device
From trunk cable B to channel B on the your device