Rockwell Automation 1786-series ControlNet Coax Media Planning and Installation Guide - Manual (Page 39)

Publication CNET-IN002B-EN-P - June 2010 39
Plan a ControlNet Coax Media System Chapter 2
The illustrations show typical mounting configurations for mounting taps on
a DIN rail.
Typical DIN Rail Mounting Configurations
Mount Using Example Requirement
Vertical T-tap and
1786-TJPR
jumper The minimum bend
radius of the
1786-TJPR jumper is
38 mm (1.5 in.).
Y-tap and
1786-TJPR
jumper
Horizontal T-tap and
transition
plate shipped
with each
T-tap
Taps must be on the
same DIN rail.
Taps must not be
bolted down to
a cabinet.
45005
45006
45004