Rockwell Automation 1766-L32 Pump Station Controller Quick Start - Manual (Page 10)

8 Publication IASIMP-QS037A-EN-P - May 2013
Chapter 1
2. Press Next to proceed to the Measuring Setup screen.
From the Measuring Setup screen you can:
– Use the Up/Down buttons to select the primary measuring device.
TIP
If Pressure Follower mode is selected then Analog "In 0" is the only option for
the primary measuring device.
– Select a secondary measuring device
TIP
If the primary measuring device is an analog device, you can assign a float to be
used as backup (not available if primary measuring is floats).
– Use the second analog input (IN 1) to measure flow rate from an
analog transmitter or as the process variable if the default analog
input (IN 0) fails.
When analog input "IN 1" (I:1.1) is set for Flow the flow is totalized
using a calculation in the PLC. A more accurate way to totalize would
be to use digital input I:0/0 as a totalized pulse.